|
One pair (2 assemblies)
of tie rod
assemblies. These assemblies are
correctly made from new old stock and fit 1953,
54, 55,
56, 57, 58, 59, 60, 61, & 62 Corvettes. As you can see from
these
photos, these are ready to paint and install and have never been on a
car. Each assembly includes one (1) left hand tie rod end with
correct
location grease fitting, seal, cancellation nut and cotter pin, one (1)
right hand tie rod end with correct location grease fitting, seal,
cancellation nut and cotter pin, one (1) tie rod
tube with two (2)
clamps, correctly marked "UR" bolts, washers, and nuts. These have
yellow paint on the RH tie rod end to indicate the outboard end.
Note
that these are correct assemblies as opposed to reproduction assemblies
with improper grease fitting locations. Don't lose points from
incorrect assemblies, which cost as much.
|